Flood Restoration 101: Understanding the Flood Cut
When flooding occurs in a Downtown Costa Mesa, CA, commercial building, a flood damage restoration team will most likely need to perform a flood cut. A flood cut is a term used to describe the process of removing the bottom 12 to 24 inches of effected drywall to prevent further contamination. Some reasons a restoration crew might perform a flood cut on your building include:
- They suspect that the underlying insulation is wet.
- The water that flooded your building is contaminated by sewage or other contaminants from outside.
- The crew suspects that secondary damage, such as mold growth or drywall rot, has already occurred.
Though it may seem counterproductive to tear out part of your building to restore it, if your restoration team recommends a flood cut, it is likely necessary. Disallowing a cut could result in secondary damage, which may end up being costlier and more damaging than a cut in the drywall.
What Happens After a Cut Is Made?
Once a cut is made above the line of flooding, your damage restoration team will remove any wet or rotted components. This may include insulation, electrical and hardware. Components that cannot be removed and replaced, such as the framing or studs, will be thoroughly cleaned so as to prevent further contamination.
For harder-to-reach areas, your team will use special equipment, such as heavy-duty pumps and vacuums, to pump water from inside the walls and dry out the interior of your building. Your team may use one or several air movers to complete the process.
Flood cuts are often necessary post-flooding, as mass amounts of water typically do not just sit on the surface. These cuts help professionals dry out hard-to-reach areas as well as serve to prevent secondary damage. If your building was recently flooded with water, contact your Downtown Costa Mesa, CA, water damage restoration team today regarding what needs to be done to dry out your building and ensure the best possible outcome.